A Equipment Rack or Rack Gear consists of spur gear teeth or helical gear tooth cut on a linear Stainless Steel Gear Rack china rectangular or round rod. Both round equipment racks and linear equipment racks can be described as a sector gear with an infinitely large radius of curvature.
The most obvious utilization of a spur gear rack is to convert the rotary movement of a pinion gear into linear movement or vise versa. When assembled, they are referred to as a rack and pinion. Rack gears provide an 
advantage over ball screws because they have a huge load carrying capacity and a straightforward design that allows linking multiple racks to meet your required length.
We carry both rectangular and circular cross-section gear rack designs in a
selection of precision pitches. All our ” and metric gear racks have machined ends for applications needing the use of multiple gear racks in a series.
When your machine’s precision movement drive exceeds what can simply and economically be performed via ball screws, rack and pinion may be the logical choice. Best of all, our gear rack comes with indexing holes and installation holes pre-bored. That saves you lots of time, hassle and expenditure.
If your travel size is more than can be acquired from a single amount of rack, no problem. Precision machined ends enable you to butt additional pieces and continue going.
A rack can be called equipment rack or just railing. They are rectangular shaped rods that are provided on one part with toothing just like a gear. By using a gear that partcipates in the toothing of the rack, you’ll be able to move the gear or the rack longitudinally. Tooth racks are utilized, among other activities, in machines in which a rotational motion must be converted to a straightforward movement or vice versa.
If power transmitting is carried out by equipment coupling, module transmission can be used. Generally the module identifies the kind of the gear in fact it is the ratio between pitch and p. Module changes based on the pitch. Here following conversion table.
The existing industry standard, these 20° pressure angle gears have thicker, stronger teeth than 14½° pressure angle gears. In comparison to plastic-type gears and racks, they’re better for high-load, high-speed, and durable applications. Also known as spur gears.